52
Special Radio Features
2. Talk and listen as usual.
3a.
For Radios Using
Only Softkeys
for
Zone
and
Channel Selection
—
When the dynamic
regrouping is
cancelled by the dispatcher, the
radio will automatically return to
the original
softkey zone and
channel before the radio was
dynamically regrouped.
• Reprogram Request
This feature allows you to notify the dispatcher that you want a new
dynamic-regrouping assignment.
1a. Press until the softkey
appears on the display.
2. Press directly below .
3. The display changes to show “REPROGRAM RQST,” and the reprogram
request is automatically sent to the dispatcher.
4a. If you hear one beep, press the
PTT Switch to resend the
reprogram request again, or
pressto hang up and return to the
home display.
If the dispatcher fails to
acknowledge the
reprogram request within
six seconds, a low-pitched
alert tone sounds and the
display changes to “NO
ACKNOWLEDGE.” Try
again or press.
Note
3b.
For Radios Using
Knobs
or
Switches
for Zone
and/or
Channel Selection
—
When the dynamic regrouping
is cancelled by the dispatcher,
the radio will automatically
return to the present knob/
switch zone and/or channel
position and the original softkey
zone or channel selection.
OR
OR
1b. Press the
Reprogram Request
Button
(see page 2); then go
to step 3.
4b. If you hear five beeps, the
reprogram request was
acknowledged by the
dispatcher, and your radio
will return to the home
display.
Special Radio Features Page 52 Wednesday, April 10, 1996 12:47 PM
To Next Page
Loading...
Need help?
General
