English
72
Controlling the Display Backlight
You can enable or disable the radio’s display backlight as
needed. The setting also affects the Menu Navigation Buttons.
Procedure:
Press the programmed Backlight Auto button to toggle the
backlight settings.
OR
Follow the procedure below.
1 c to access the menu.
2 < or > to Utilities and press e to select.
3 < or > to Radio Settings and press e to select.
4 < or > to Backlight Auto.
5 Press e to enable backlight. The display shows 9 beside
Enabled.
OR
Press
e to disable backlight. The 9 disappears from
beside Enabled.
The display backlight are automatically turned off if the LED
indicator is disabled (see Turning the LED Indicator On or Off
on page 74).
NOTE: At Step 4, you can also use
< or > to change the
selected option.
Setting the Squelch Level
You can adjust your radio's squelch level to filter out unwanted
calls with low signal strength or channels that have a higher
than normal background noise.
Settings: Normal is the default. Tight filters out (unwanted)
calls and/or background noise. However, calls from remote
locations may also be filtered out.
Procedure:
Press the programmed Squelch button to toggle squelch level
between normal and tight.
OR
Follow the procedure below.
1 c to access the menu.
2 < or > to Utilities and press e to select.
3 < or > to Radio Settings and press e to select.
4 < or > to Squelch and press e to select.
5 The display shows Tight and Normal. < or > to the
required setting and press
e to enable. 9 appears besides
selected setting.
6 Screen returns to the previous menu.
LKP_APAC.book Page 72 Wednesday, July 18, 2012 11:01 AM
To Next Page
Loading...