Section 1: 2-8 Notes For All Schematics and Circuit Boards
6881091C63-F
OPT PTT PTT from Option Board
PA PWR SET ASFIC Output Voltage to set the Transmitter
Power
PA SWB Switches Supply Voltage for PA Current Control
Circuitry
PA SUPVLTG 13.2 V Supply Voltage of the Transmitter PA
PCIC MOSBIAS 1 PA Bias Voltage for First Stage
PRESC Prescaler Signal from VCO to Synthesizer
PTT IRDEC Microphone PTT Input
PTT IRDECODER Microphone PTT Input
R W Read Write Signal for RAM / Flash
RAM CS RAM Chip Select
RDY Service Request Line from Option Board
REF CS Reference Chip Select (not used)
RESET Reset Line
ROW x Keypad Matrix Row x
RSSI Received Signal Strength Indicator
RX ADAPT Flat TX Path Disable during Transmitter Key-up
RX AUD RTN Option Board Input / Output of Receiver Audio
Path
RX FLAT FILTERED AUDIO Flat or Filtered Audio to Accessory Connector
RXIN RF Signal from Antenna Switch into the Receiver
RXINJ RF Signal from the VCO into the Mixer
SCI RX Serial Communication Interface Receive Line
SCI TX Serial Communication Interface Transmit Line
SPI Serial Peripheral Interface Bus
SPKR- Negative Audio PA Speaker Output
SPKR+ Positive Audio PA Speaker Output
SQ DET Squelch Detect Signal
SYN µP Clock Signal
TEMP SENSE Temperature Sense Line for LCD
TEMPSENSE Temperature Sense Line from PA to µP
TRB TX/RX VCO Switch Signal
TX AUD RTN Option Board Output to Transmit Audio Path
TX AUD SND Microphone Audio to Option Board
TXINJ RF Signal from the VCO into the Transmitter PA
U DRIVER Supply Voltage for PA Driver
U PREDRIVER Supply Voltage for PA Pre-driver
UNSW 5V Permanent 5V Supply
URX SND Filtered Audio Signal to Option Board
VAG 2.5V Reference Voltage for Analog Circuitry
To Next Page
Loading...
Need help?
General
