Quick Reference Guide 13
2. Ensure that the mobile computer is “on and awake” (not in Suspend mode).
3. The Imager automatically attempts reconnecting to the mobile computer for 30
seconds (Scan LED flashes green). If automatic re-connection fails, verify that
the Imager is within Bluetooth range and briefly press the Restore Key on the
Imager to reconnect.
4. The Scan LED starts flashing green indicating that the Imager is attempting to
establish connection with a mobile computer.
5. The Scan LED turns off and the Imager emits one string of low/high beeps
indicating that the Imager is connected and ready for scanning.
To Next Page
Loading...
