Maintenance, Troubleshooting & Technical Specifications 3 - 5
Cradle has lost connection to
host.
In this exact order: disconnect power
supply; disconnect host cable; wait
three seconds; reconnect host cable;
reconnect power supply; reestablish
pairing.
Scanner emits five long low beep
after a bar code is decoded.
Conversion or format error was
detected.
The scanner’s conversion
parameters are not properly
configured.
Ensure the scanner’s conversion
parameters are properly configured.
Conversion or format error was
detected.
An ADF rule was set up with
characters that can't be sent for
the host selected.
Change the ADF rule, or change to a
host that can support the ADF rule.
Conversion or format error was
detected.
A bar code was scanned with
characters that can't be sent for
that host.
Change the bar code, or change to a
host that can support the bar code.
Host Displays
Host displays scanned data
incorrectly.
Scanner is not programmed to
work with the host.
Ensure the proper host is selected.
Scan the appropriate host type
programming bar code.
For RS-232, ensure the scanner’s
communication parameters match the
host’s settings.
For a USB HID keyboard or Keyboard
Wedge configuration, ensure the
system is programmed for the correct
keyboard type and language, and turn
off the CAPS LOCK key.
Ensure editing options (e.g., ADF,
UPC-E to UPC-A Conversion) are
properly programmed.
Check the scanner’s host type
parameters or editing options.
Table 3-1
Troubleshooting (Continued)
Problem Possible Causes Possible Solutions
To Next Page
Loading...
