3 - 6 Symbol LS4278 Product Reference Guide
Trigger
Nothing happens when the trigger is
pulled.
No power to the scanner. Check the system power. If the
configuration requires a power supply,
re-connect the power supply.
Check the battery. Ensure that end cap
to battery chamber is secured.
Interface/power cables are loose. Check for loose cable connections and
re-connect cables.
Scanner is disabled. For Synapse or IBM-468x mode,
enable the scanner via the host
interface.
The laser does not appear when the
trigger is pulled.
No power to the scanner. Check the system power. If the
configuration requires a power supply,
re-connect the power supply.
Incorrect host interface cable is
used.
Verify that the correct host interface
cable is used. If not, connect the
correct host interface cable.
Interface/power cables are loose. Check for loose cable connections and
re-connect cables.
Table 3-1
Troubleshooting (Continued)
Problem Possible Causes Possible Solutions
NOTE If after performing these checks the symbol still does not scan, contact the distributor or contact Motorola
Support. See page xvii for contact information.
To Next Page
Loading...
