6809495A43-C April 03, 2006 47
Level 1 and 2 Service Manual Troubleshooting
Programming: Software Upgrade and Flexing
Contact your local technical support engineer for information about equipment and
procedures for flashing and flexing.Part Numbers
The following information is provided as a reference for the parts associated with
V235 telephones.
Related Publications
8. Phone does not sense when flip is
opened or closed (usually indicated by
inability to answer incoming calls by
opening the flip, or inability to make
outgoing calls).
a) Transceiver board assembly
defective.
Replace the transceiver board assembly (refer
to 1c). Verify that the fault has been cleared
and reassemble the unit with the new
transceiver board assembly.
10. Internal Charger not working.
Faulty charger circuit on transceiver
board assembly.
Test a selection of batteries in the rear pocket
of the desktop charger. Check LED display for
the charging indications. If these are charging
properly, then the internal charger is at fault.
Replace the transceiver board assembly (refer
to 1c). Verify that the fault has been cleared
and reassemble the unit with the new
transceiver board assembly.
11. Real Time Clock resetting when
standard battery is removed.
Lithium button cell in the display
board may be depleted.
Refer service to a Level 3 service center for
replacement.
12. No or weak audio when using
headset. a) Headset not fully pushed home.
Ensure the headset plug is fully seated in the
connector socket. If fault not cleared, proceed
to b.
b) Faulty connector socket on
transceiver board assembly.
Replace the transceiver board assembly (refer
to 1c). Verify that the fault has been cleared
and reassemble the unit with the new
transceiver board assembly.
Motorola V235 User’s Guide, English SJJN6409A (6809482A70)
Table 4. Level 1 and 2 Troubleshooting Chart (Continued)
SYMPTOM PROBABLE CAUSE VERIFICATION AND REMEDY
To Next Page
Loading...
