Powering Up the Radio
Follow the procedure to power up your radio.
Rotate the On/Off/Volume Control Knob
clockwise until a click sounds.
• A tone sounds.
• The green LED lights up.
Note:
There is no tone upon powering up if the
Tones/Alerts function is disabled. See Turning
Radio Tones/Alerts On or Off on page 50 for
more information.
Check your battery if your radio does not power up.
Make sure that it is charged and properly attached.
Contact your dealer if your radio still does not power
up.
Turning Off the Radio
Follow the procedure to turn off your radio.
Rotate the On/Off/Volume Control Knob
counterclockwise until a click sounds.
Adjusting the Volume
Follow the procedure to change the volume level of
your radio.
Do one of the following:
• Turn the On/Off/Volume Control Knob
clockwise to increase the volume.
• Turn the On/Off/Volume Control Knob
counterclockwise to decrease the volume.
Note:
Your radio can be programmed to have a
minimum volume offset where the volume
level cannot be lowered past the
programmed minimum volume. Check with
your dealer or system administrator for
more information.
16
English
To Next Page
Loading...
