• Press the programmed One Touch Access
button.
2 Press the PTT button to make the call.
The green LED lights up.
3 Wait for the Talk Permit Tone to end and speak
clearly into the microphone if enabled.
4 Release the PTT button to listen.
5
If the Channel Free Indication feature is
enabled, you hear a short alert tone the moment
the transmitting radio releases the PTT button,
indicating the channel is free for you to
respond.Press the PTT button to respond to the
call.
The call ends when there is no voice activity for a
predetermined period.A tone sounds.
All Calls
An All Call is a call from an individual radio to every
radio on the channel. An All Call is used to make
important announcements, requiring full attention
from the user. The users on the channel cannot
respond to an All Call.
Receiving All Calls
When you receive an All Call:
• A tone sounds.
• The green LED blinks.
• Your radio unmutes and the incoming call sounds
through the speaker.
An All Call does not wait for a predetermined period
before ending.
If the Channel Free Indication feature is enabled,
you hear a short alert tone when the transmitting
radio releases the PTT button, indicating the channel
is free for you to use. You cannot respond to an All
Call.
Note:
The radio stops receiving the All Call if you
switch to a different channel while receiving
the call. You are not able to continue with any
programmed button functions until the call
ends during an All Call.
30
English
To Next Page
Loading...
