Motorola XPR 3300 - Scan; Turning Scan On or Off; Responding to Transmissions During Scanning

sequence specified in the scan list for the current
channel or group.
Your radio can support up to 250 scan lists, with a
maximum of 16 members in a list. Each scan list
supports a mixture of both analog and digital entries.
Scan
Your radio cycles through the programmed scan list
for the current channel looking for voice activity when
you start a scan.
The LED blinks yellow.
There are two ways of initiating scan:
Main Channel
Scan (Manual)
Your radio scans all the channels
or groups in your scan list. On
entering scan, your radio may,
depending on the settings,
automatically start on the last
scanned active channel or group,
or on the channel where scan was
initiated.
Auto Scan
(Automatic)
Your radio automatically starts
scanning when you select a
channel or group that has Auto
Scan enabled.
Turning Scan On or Off
Follow the procedure to turn scan on or off on your
radio.
Do one of the following:
• Press the programmed Scan button to start or
stop Scan.
• Turn the Channel Selector Knob to select a
channel programmed with a scan list.
If scan is enabled:
• The yellow LED blinks.
• A positive indicator tone sounds.
If scan is disabled:
• The LED turns off.
• A negative indicator tone sounds.
Responding to Transmissions During Scanning
During scanning, your radio stops on a channel or
group where activity is detected. The radio stays on
that channel for a programmed duration known as
Advanced Features
36
English