Follow the same procedures as Responding to
Transmissions During Scanning on page 36 to
respond to a transmission during a vote scan.
Call Indicator Settings
Selecting a Ring Alert Type
Note:
The programmed Ring Alert Type button is
assigned by your dealer or system
administrator. Check with your dealer or
system administrator to determine how your
radio has been programmed.
You can program the radio calls to one
predetermined vibrate call.
The radio sounds one vibration if it is a momentary
ring style. The radio vibrates repetitively if it is a
repetitive ring style. When set to Ring and Vibrate,
the radio sounds a specific ring tone if there is any
incoming radio transaction (for example, Call Alert or
Message). It sounds like a good key tone or missed
call.
For radios with batteries that support the vibrate
feature and are attached to a vibrating belt clip, the
available Ring Alert Type options are Silent, Ring,
Vibrate, and Ring and Vibrate.
For radios with batteries that do not support the
vibrate feature and are not attached to a vibrating belt
clip, Ring Alert Type is automatically set to Ring.If you
press the programmed Ring Alert Type button, a bad
key tone sounds, indicating the multiple Ring Alert
Type options are disabled.
You can select a Ring Alert Type by performing the
following action.
Press the programmed Ring Alert Type button to
toggle Voice Announcement or Text-to-Speech,
and the radio behavior to the following options.
• For Silent, Voice Announcement or Text-to-
Speech sounds Ring Alert Type Silent only.
• For Ring Only, Voice Announcement or Text-
to-Speech sounds Ring Alert Type and the
radio sounds a ring tone.
• For Vibrate Only, Voice Announcement or Text-
to-Speech sounds Ring Alert Type and the
radio vibrates.
• For Ring and Vibrate, Voice Announcement or
Text-to-Speech sounds Ring Alert Type and
the radio sounds a ring tone and vibrates.
38
English
To Next Page
Loading...
