Motorola XTS 2500

1
Introduction
1
General This manual covers information needed for level one and two troubleshooting. Level one
troubleshooting consists of radio programming, tuning (via CPS/tuner), knobs
replacement, and installation and removal of antenna, belt clip, battery, and universal
connector cover. Level two troubleshooting consists of everything listed in level one, plus
the identification and replacement of Field Replaceable Units (FRUs). No soldering will be
allowed; only board swapping.
Included in this manual are radio specifications for the 700/800 MHz frequency bands, a
general description of ASTRO Digital XTS 2500 models, recommended test equipment,
service aids, radio alignment procedures, general maintenance recommendations, and
procedures for basic assembly and disassembly.
Notations Used in
This Manual
Throughout the text in this publication, you will notice the use of warnings, cautions, and
notes. These notations are used to emphasize that safety hazards exist, and care must be
taken and observed.
NOTE: An operational procedure, practice, or condition, etc., which is
essential to emphasize.
CAUTION indicates a potentially hazardous situation which, if not
avoided, may
result in equipment damage.
!
C a u t i o n
WARNING indicates a potentially hazardous situation which, if
not avoided, could
result in death or injury.
!
W A R N I N G
!
DANGER indicates an imminently hazardous situation
which, if not avoided, will
result in death or injury.
D A N G E R
!