Disassembly/Assembly
49
Display
Disassembly
For this section, please refer to the Model III exploded view and parts list on page 35 for
part numbers and more information on the location of parts in the radio. (For the Model II
display, please refer to the exploded view and parts list on page 34.)
1. The display assembly can be removed without the disassembly of the keypad board or
the speaker-microphone flex assembly. If the disassembly involves the removal of the
display module, disconnect the display flex from the keypad option board connector.
2. The display module snaps into the front cover assembly. Insert two flat-bladed
screwdrivers between the flexible beam at the top of the display module (one on each
side). Deflect the beam down until it moves past the hooks on the front cover. The
display module is hooked to the front cover at the base of the display. Lift the top of
the display module past the hooks and remove it from the front cover.
Table 20. Display Disassembly
Exploded
View Item
Number
Motorola Part Number Description
1 1585746D03 Cover, Front Assembly Kit (Model III)
2 0185948D01 Keypad Board, Model III
6 7285726C01 Display Module
9 4285214D01 Retainer, Keypad
Take care not to damage the display. Do not cut, bend, or pinch the heat
seal. Display modules contain CMOS devices. Be sure to use ESD
protection.
Figure 36. Display Disassembly
!
C a u t i o n
To Next Page
Loading...
