Trigger Box Quick Start Guide
17
Returning the Trigger Box to normal working mode
1. Turn Off the internal simulated camera (Sync generator) by
switching off the INT CAM CONTROL ON/OFF (CAM RUN LED
Off)
2. Switch Off the CAM TEST ON/OFF switch so that the Trigger Box
uses its external CAM ON/OFF and EXT. SYNC connectors again.
Even if you are not using these connectors, setting this switch to Off
prevents any accidentally generated Sync signal (from the Trigger
Box) from interfering with the real Sync signal coming from the
camera.
3. Plug the Trigger Box back into the ribbon cable connector that suits
your requirements (see Connecting the cables on page 2).
4. In Flair, in the Setups > External Camera Setup pop-up, change the
settings back to those appropriate for your camera.
To Next Page
Loading...