Troubleshooting
FS-B35XX Series Start-up Guide 17
6 Troubleshooting
6.1 Communicating with the FieldServer Over the Network
• Confirm that the network cabling is correct.
• Confirm that the computer network card is operational and correctly configured.
• Confirm that there is an Ethernet adapter installed in the software configuration, and that it is
configured to run the TCP/IP protocol.
• Open Command Prompt.
• Type in “ipconfig”.
• The account settings should be displayed.
• Ensure that the IP address is on the same Subnet of the FieldServer.
o Default N1 IP Address is 192.168.2.101
o Default N2 IP Address is 192.168.3.101
• The IP address of the FieldServer can be changed using the FS-GUI. Refer to the FieldServer FS-
GUI manual for more information.
To Next Page
