Installation
PrimaX
14
GB
Wall or Pipe Mounting
For pipe mounting a pipe mounting kit is necessary [ chapter 8.6].
Install the Backplate
(1) Use the two keyhole slots for attaching
the mounting plate to the wall. Use 6mm
diameter screws and suitable plugs.
(2) For a wall installation use the backplate
as a template for drilling the holes for the
two fixing screws, for a pipe installation
use the pipe clip.
(3) Attach the backplate to the wall or the
pipe clip with M6 x 20 screws.
The hitch should point away from the
wall or pipe.
The straight edge of the backplate
should be at the bottom.
Attach the Device to the Backplate
(4) Attach the device to the top of the back-
plate.
(5) Fold down the device, till it is closed to
the backplate.
Fasten Device
(6) Screw the device to the backplate.