Installing the Ultima X Remote Sensor Module
The Remote Sensor Module is used with the Ultima X Gas
Monitor/less sensor.
The Remote Sensor Module can be mounted in a manner similar
to the gas monitor installation in the preceding procedure and at
a maximum distance outlined in TABLE 1-5.
Permanently connect 1/4" ID tubing to the post on the windguard.
Route this tubing to the Ultima X Gas Monitor, ensuring that
there are no kinks, leaks or other obstructions. Secure this tubing
near the monitor; it is used to deliver check gas to the sensor
module during calibration.
Electrical Connections for the Ultima X Series
Remote Sensor Module
"!
WARNING
Before wiring the Ultima X Series Remote Sensor Module,
disconnect the power source feeding the Remote Sensor Module
and the Ultima X Series Gas Monitor/Less Sensor; otherwise,
electrical shock could occur.
"!
CAUTION
When installing an Ultima X Series Remote Sensor Module with
its mating Ultima X Series Gas Monitor/Less Sensor, follow National
Electrical and local procedural Codes; failure to do so can result
in an unsafe condition.
Five conductors are required for the Ultima XE and Ultima XA
Remote Sensor Modules. Four conductors are required for the
Ultima XIR Remote Sensor Module. The Ultima X Series Monitor
has a five-wire terminal to accommodate up to #16 AWG
conductors.
Some installations require metal pipe or metallic conduit. In these
cases, separate conductors or unshielded cable may be used.
For open wiring, shielded wire or cable should be used to
minimize the possibility of noise interference and contact with
other voltages. Selection of this shielded cable must comply with
local requirements.
Chapter 1, Installation
1-12
To Next Page
Loading...
Need help?
General
