5. Main Menu
12 ENGLISH
Press the p or q button to select the menu item SYSTEM UPGRADE. In this menu, you can
update the firmware of the monitor, or the cameras.
1. Copy the firmware to an SD card or a USB stick and plug it into the monitor.
2. Select „Upgrade Firmware local“ with the p or q key and confirm with OK. Now press to start
the update process button (record button). A popup message appears. Press OK to confirm
or MENU to cancel.
Press the p or q button to select the menu item SCAN MODE PERIODE. In this menu you can
set the interval of the video. If you have for example connected four cameras and set the monitor
to single-image display, change the camera images automatically after a certain time. You can
have an interval of 5, 10, set 15, 20 or 30 seconds.
Press the p or q button to select the menu item MUTE. In this menu you can turn on or off the
volume of the monitor.
Press the p or q button to select the menu item LOAD DEFAULT. In this menu, the monitor can
be reset to the default setting. All the settings you have made are lost. Confirm the operation by
clicking OK, or select „Cancel“ to leave the menu.
Press the p or q button to select the menu item „BRIGHTNESS“. In this menu you can adjust
the brightness of the monitor. Use the t or u keys to adjust brightness. Confirm with OK to save
and exit the menu.
System Upgrade
Scan Mode Periode
Mute
Load Default
Brightness
To Next Page
Loading...