MTS 793 Controller Hardware
FlexTest GT Controller Connections
106
Cable specification The cable specifications apply to both the analog inputs and analog
outputs.
The cable from the front panel of the I/O Carrier module has the
following specification:
• 15-contact type D male EMI connector.
• Backshell–EMI metallized plastic.
• Cable type–up to 6 shielded twisted pairs, each with the drain
wire connected to the signal source.
The cable to the Ch 1 - Ch 6 connectors on the rear panel have the
following specifications:
• BNC connector UG88/U
• Cable–RG-58 coaxial
• Use of a smaller coaxial cable and a RG-174 BNC connector with
an appropriate cable end is permissible.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...