MTS Systems FlexTest IIm - Encoder Connections; I;O Carrier Module Configuration

MTS 793 Controller Hardware FlexTest GT Controller Connections
109
Encoder Connections
I/O Carrier Module
Configuration
For an ADDA configuration using an I/O Carrier module, each encoder
requires installation of a Model 493.47 Encoder Interface mezzanine
card on the Model 493.40 I/O Carrier board. The I/O Carrier connector
is based on the location of the mezzanine card installed on the board
of the I/O Carrier module.
J6 I/O
J7 I/O
493.40
I/O Carrier
J3 Service
Shunt Cal
J4 I/O
J5 I/O
m
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com