MTS 793 Controller Hardware FlexTest GT Controller Connections
111
Remote Setpoint Adjust Connections
A Remote Setpoint Adjust (RSA) control is an optional, standalone
hardware device that uses an incremental or absolute encoder to
control actuator setpoints.
Each RSA control pod requires installation of a Model 493.47 Encoder
Interface mezzanine card on the Model 493.40 I/O Carrier board. The
I/O Carrier connector is based on the location of the mezzanine card
installed on the board of the I/O Carrier module.
See “Setting Up the Remote Setpoint Adjust” in the MTS 793 Control
Software manual for more information.
Remote Setpoint Pod
100-051-058
J6 I/O
J7 I/O
493.40
I/O Carrier
J3 Service
Shunt Cal
J4 I/O
J5 I/O
m
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...