MTX MTX-3G-JAVA-IoT - 16. AT Command Summary

MTX-xG-JAVA-IoT Family
www.mtxm2m.com 2017/07 v1.2 Page 102/105
MTX M2M® by MATRIX ELECTRONICA S.L.U
AT^SISI
Internet Service Information
AT^SISO
Internet Service Open
AT^SISR
Internet Service Read Data
AT^SISS
Internet Service Setup Profile
AT^SIST
Enter Transparent Access Mode
AT^SISW
Internet Service Write Data
AT^SISX
Internet Service Execution
AT^SJAM
Manage Java Application
AT^SJDL
Java Download
AT^SJMSEC
Java Midlet Security
AT^SJNET
Set Dialup Network Access Parameters
AT^SJOTAP
Over The Air Application Provisioning
AT^SJRA
Run Java Application
AT^SLED
LED Feature
AT^SMGL
List Short Messages from preferred store without setting status to REC READ
AT^SMGR
Read short message without setting status to REC READ
AT^SMONI
Monitoring Serving Cell
AT^SMONP
Monitoring Neighbour Cells
AT^SMSO
Switch Off EHS6
AT^SNFI
Set microphone path parameters
AT^SNFM
Set microphone audio path and power supply
AT^SNFO
Set audio output (= loudspeaker path) parameter
AT^SNFS
Select audio hardware set
AT^SNFTTY
Signal TTY/CTM audio mode capability
AT^SNMON
Network monitoring
AT^SPIO
GPIO Driver Open/Close
AT^SPOW
Set UART Mode and SLEEP Mode on UART
AT^SRADC
Configure and Read ADC Measurement
AT^SRTC
Ring tone configuration
AT^SSCNT
Start and Stop Pulse Counter
AT^SSIO
Set IO state of a specified pin or port
AT^SSPI
Serial Protocol Interface
AT^SSTA
Remote-SAT Interface Activation
AT^SWDAC
PWM Signal Configuration for DAC
AT^SXCALLSTAT
Set Reporting Call Status
AT^SXEONS
Display Eons names
AT^SXRAT
Selection of Radio Access Technology
ATA
Connect to Incoming Call
ATA
Manual acceptance of a network request for PDP context activation
ATD
Mobile originated call to specified number
ATD*99#
Request Packet Domain Service
ATD><mem><n>
Mobile originated call using specific memory and index number
ATD><n>
Mobile originated call from active memory using index number
ATD><str>
Mobile originated call from active memory using corresponding field
ATDL
Redial last number used