MTX-xG-JAVA-IoT Family
www.mtxm2m.com 2017/07 v1.2 Page 76/105
MTX M2M® by MATRIX ELECTRONICA S.L.U
5.2.2 Low Power mode
In this mode, all the board devices are disconnected from the power supply, except the internal
coprocessor, that allows the modem to exit from this mode and go back into the normal mode. In this
mode the MTX-IoT requires 100µA to supply the internal logic.
When a LP modem enters in Low Power mode, the device will wake up again when it receive a
character sent from any of the serial interfaces (RS232 or RS485)
To learn how to configure and enter into the Low Power mode please read the MTX-IoT Family
Software Manual
To Next Page
Loading...