Configuring the job computer for work
Calibrating the flow meter
7
Injury caused by working machine
If the function is activated when the implement is at a standstill, the driver can activate functions that
can otherwise only be activated during travel. This can cause injury to persons standing close to the
implement.
◦ Make sure that no one is close to the implement.
1. On the work screen, press:
> ( ) > > >
2. In the “Simulated speed” parameter, enter the speed to be simulated.
⇨ The desired speed will be simulated.
Calibrating the flow meter
You must calibrate the flow meter in the following cases:
▪ Prior to initial start-up.
▪ At the start of each season.
▪ If you notice that there are deviations between the applied quantity and the displayed quantity.
▪ After repairs performed on the flow meter.
If the calibration is imprecise, the calculations will be very inaccurate and the application imprecise.
◦ Calibrate the flow meter very precisely.
Slurry or slurry residues
Risk of poisoning or corrosion
◦ Clean the tank before calibration.
◦ Only use clear water for the calibration.
◦ Wear required protective equipment.
The tank is filled with water. You need several hundred litres of water.
You have a method for measuring the quantity of applied water.
The pump is switched on.
1. Drive the slurry tanker to a position where you can apply the water without any problems.
2. On the work screen, press:
> ( ) >
⇨ The “FLOW METER” screen appears.
To Next Page
Loading...
Need help?
General
