Muller Elektronik SLURRY-Controller 3.0 User Manual

Troubleshooting
Checking the software version
8
30322453-02-EN
V4.20191001
57
Alarm text
Possible cause
Remedial measure
Error - Pressure sensor There is a measuring error on the
pressure sensor.
Check the pressure sensor.
Error - Control valve There is a measuring error on the control
sensor.
Check the control valve.
Error - System
There is a system error.
Check the system.
Value too big for the display.
A value cannot be displayed.
Check the settings for the units.
Hydraulic axle drive – PTO shaft speed is
too low.
The rotational speed of the PTO shaft is
too low.
I Increase the rotational speed of the PTO
shaft.
Hydraulic axle drive – Oil pressure is too
low.
The oil pressure is too low. Increase the oil pressure.
Hydraulic axle drive – Drive speed is too
high.
The drive speed of the hydraulic axle drive
is too high.
Reduce the speed of the hydraulic axle
drive.
Hydraulic axle drive (expert) – Activation is
impossible.
Activation of the hydraulic axle drive is
impossible.
Check whether the system is connected to
the power supply.
Hydraulic axle drive (expert) – Incorrect
change of the driving direction detected.
The driving direction was not recognised
by the ISOBUS.
Check the driving direction settings.
The drawbar angle sensor is not correctly
installed.
The drawbar angle sensor is not correctly
installed.
Correctly install the angle sensor.
Calibration required.
The calibration is faulty.
Calibration is required.
Defective drawbar angle sensor.
The drawbar angle sensor is defective.
Replace the angle sensor.
Concentration is too low for regulation. The concentration of the slurry is too low
for regulation.
Increase the concentration.
MUT sensor is not connected. The job computer cannot establish a
connection to the MUT sensor.
Check the wiring.
License is not activated. The licence for the selected function (e.g.
MUT sensor) is not activated.
Activate the licence.
Checking the software version
To check the software version of the job computer, you must enter the password. [➙ 52] The
software version then appears on the “SETTINGS” screen under the “Connected ECU” parameter.
8.2

Muller Elektronik SLURRY-Controller 3.0 Specifications

General

Brand	Muller Elektronik
Model	SLURRY-Controller 3.0
Category	Controller
Language	English