Muller Elektronik SLURRY-Controller 3.0 User Manual

8
Troubleshooting
Alarm messages
56
V4.20191001
30322453-02-EN
Alarm text
Possible cause
Remedial measure
Right-hand sensor is disabled.
The right-hand sensor is disabled.
Check the sensor and activate it.
The left-right valve is disabled.
The left-right valve is disabled.
Check the left-right valve and activate it.
The raise-lower valve is disabled. The raise-lower valve is disabled. Check the raise-lower valve and activate
it.
Support leg is extended. Driving on roads
is not possible.
The support leg is extended. Retract the support leg completely when
driving on roads.
You cannot activate this function while
driving.
A function that only works when standing
still has been activated.
Come to a stop in order to perform the
function.
Function not possible, when speed is not
within permissible range.
A function was activated outside of the
permissible speed range.
Perform the function at the defined
permissible speed.
Overpressure in top link
The pressure in the top link is too high.
Set the optimal pressure.
Tyre pressure is too low.
The pressure in the tyres is too low.
Set the optimal pressure.
Tyre pressure is too high.
The pressure in the tyres is too high.
Set the optimal pressure.
Timeout - Tyre Inflation System The tyre inflation system cannot reach the
set pressure.
Check the tyre inflation system.
The speed is too high. Steering system is
deactivated.
The permissible maximum speed for the
steering system is too high.
Observe the permissible maximum speed
for the steering system.
Error. Steering system is deactivated. Error message from the steering system. Restart the system. If the error persists,
contact Customer Service.
The mounted implement is not folded. The
speed is too high.
The speed is too high for folding the
mounted implement.
Reduce the speed and then fold the
mounted implement.
The speed is too high. The support wheel
is lowered.
The speed is too high. Reduce the speed.
Overpressure in support wheel The pressure in the support wheel is too
high.
Set the optimal pressure.
The support wheel may not be operated.
The speed is too high.
The speed is too high. Reduce the speed.
Tyre temperature is too high.
The tyre temperature is too high.
The tyre temperature is too high.
Error – Raise the chassis. Function not
possible.
The chassis cannot be raised. Check the hydraulic system and
mechanics of the chassis.
Error - Angle sensor There is a measuring error on the angle
sensor.
Check the angle sensor.

Muller Elektronik SLURRY-Controller 3.0 Specifications

General

Brand	Muller Elektronik
Model	SLURRY-Controller 3.0
Category	Controller
Language	English