7
Configuring the job computer for work
Configuring the mounted implement
The section is blocked.
The section is not assigned to a section group.
The section is assigned to the first section group.
The section is assigned to the second section group.
The section is assigned to the third section group.
The section is assigned to the fourth section group.
1. On the work screen, press:
> ( ) >
2. Enter the settings required.
3. Restart the terminal.
Configuring the mounted implement
Use the following parameter on the “SETTINGS” screen for the configuration:
“Mounted Implement” parameter
Select the mounted implement that you are using:
▪ “Arable injector”
▪ “Grassland injector”
▪ “Trailing hose distributor”
▪ “Trailing shoe distributor”
▪ “Splash plate”
“Number of Sections” parameter
The number of sections on the mounted implement is always taken from the Configuration of the
sections [➙ 49]. You cannot change the value here.
“Working Width” parameter
The working width consists of the sum of the widths of all of the sections. To change the working
width, you must Reconfigure the sections. [➙ 49]
To Next Page
Loading...
Need help?
General
