Muller Elektronik SLURRY-Controller 3.0 User Manual

Troubleshooting
Alarm messages
8
30322453-02-EN
V4.20191001
55
Alarm text
Possible cause
Remedial measure
Maximum speed exceeded. The permissible maximum speed for the
steering system has been exceeded.
Observe the permissible maximum speed
for the steering system.
The speed is too high. The driving speed for this function is too
high.
Reduce the driving speed.
The speed is too low. The driving speed for this function is too
low.
Increase the driving speed.
Pressure is not within set range. The pressure is not in the defined range. Check the pressure and set it to the
defined value.
Fold/Unfold is forbidden at this speed. The driving speed is too high for
folding/unfolding.
Come to a stop or reduce the speed for
folding/unfolding.
Overpressure in chopper.
The chopper is clogged.
Remove the obstruction.
Gear: Rotational speed is too high.
The gearbox rotational speed is too high.
Reduce the rotational speed.
Angle sensor of first element is faulty or
outside of measurement range.
The sensor is faulty or outside of the
measurement range.
Check the sensor and replace it if
necessary.
Angle sensor of second element is faulty
or outside of measurement range.
The sensor is faulty or outside of the
measurement range.
Check the sensor and replace it if
necessary.
Angle sensor of third element is faulty or
outside of measurement range.
The sensor is faulty or outside of the
measurement range.
Check the sensor and replace it if
necessary.
Angle sensor of rotating arm is faulty or
outside of measurement range.
The sensor is faulty or outside of the
measurement range.
Check the sensor and replace it if
necessary.
Function is disabled at current speed. The driving speed is too high for this
function.
Reduce the driving speed.
Mounted implement not in transport
position.
The mounted implement is not in transport
position.
Put the mounted implement into transport
position.
Faulty configuration. The configuration does not correspond to
the software.
Contact Customer Service.
To activate this function, restart the job
computer.
The function requires a restart. Restart the system.
The configuration is being transferred. The configuration is being transferred to
other job computers.
Wait until the configuration is completely
transferred. Do not disconnect the job
computer from the power source.
Tank is almost full.
The fill level sensor detects that the tank is
almost full.
Observe the rest of the filling procedure.
Left-hand sensor is disabled.
The left-hand sensor is disabled.
Check the sensor and activate it.

Muller Elektronik SLURRY-Controller 3.0 Specifications

General

Brand	Muller Elektronik
Model	SLURRY-Controller 3.0
Category	Controller
Language	English