Munters Rotem Trio Installation Manual

© Munters AB, 2020 11
3.1.1.2 Installation and Electrical Connections
•
Install computerized electronic controls at least three feet (one meter) away from
interference sources such as high voltage wiring to motors, variable speed, light
dimmers, relays.
•
Install electronic controls in a separate ventilated control room that is protected
from extreme temperatures and dirty environments. Place the controls so that the
operators can conveniently use the control and read indicators and displays.
•
Keep low voltage wires separate from high voltage wires.
•
Use shielded wiring for low level signals. For buried wiring (building to building
runs) use high grade jell filled cables that are impervious to moisture.
•
Seal cable entry points and control boxes to prevent contamination and corrosion.
If you use silicon sealant with acetic acid cure, keep the control open and
ventilated until cured. Otherwise, the acetic acid will attack the metal parts,
including circuitry.
3.1.2 W
HAT
C
OMES IN THE
P
ACKAGE
•
One Trio unit
•
One hanging bracket
•
Two screws
3.2 Mounting the Unit
•
Knockouts
•
Hanging the Unit
3.2.1 K
NOCKOUTS
1. Using the supplied clips and screws, mount the Trio.
2. On the bottom the Trio are knockouts used to route the low and high voltage
cables.
Figure 1: Trio
Knockouts and PG Size
o
Using a screwdriver and a hammer, gently apply pressure to the knockouts.
o
Only open the holes that you require.

Munters Rotem Trio Specifications

General

Brand	Munters
Model	Rotem Trio
Category	Farm Equipment
Language	English