© Munters AB, 2020 40
7
Mapping and Defining the Input
Output Devices
NOTE Munters recommends that a trained technician perform the following operations.
•
Mapping Devices
•
Temperature Sensors
•
Ventilation Devices
•
Sensors
•
Heating Devices
•
Defining the Cooling Devices
•
Potentiometers, Inlets, Tunnel Doors, Outlets
•
Defining the Sprinkler
•
Defining the Same As Relays
•
Defining the Same As Analog Ports
•
Defining the Timer
•
Defining the Auxiliary Input
•
Defining the Measuring Fan
•
Feeding Devices
•
Trio RPS
7.1
Mapping Devices
After wiring devices to the Trio, each device must be mapped and then defined. Mapping
and defining devices enable the system software to control each device’s functionality.
CAUTION Mapping MUST match the physical wiring! An error message appears if the
physical device is not wired to the relay or port as defined on the mapping screen.
To Next Page
Loading...
Need help?
General
