EasyManuals Logo

Munters Rotem Trio Installation Manual

Munters Rotem Trio
128 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
© Munters AB, 2020 12
o
Munters recommends removing the knockouts before mounting the unit.
o
16*: Use this knockout for the Ethernet cable.
3. Place the required cables through the cable holders at the bottom of the unit.
CAUTION Run low voltage cables through one knockout and high voltage relay cables
through a separate knockout. Do not place them in the same knockout!
4. Close the Trio enclosure lid carefully and tightly. Use RTV silicon or equivalent
sealant to seal the cable holders.
CAUTION Munters strongly recommends that you seal all entry spots with RTV silicon.
Failure to do so can lead to damage to the unit.
5. After installation is completed, operate the Trio for a few hours and re- check for
proper operation.
3.2.2 H
ANGING THE
U
NIT
1. Attach the bracket to the wall (customer supplies the screws).
2. Hang the Trio on the bracket.
3. Secure the unit to the wall using the two screws provided (optional).

Table of Contents

Other manuals for Munters Rotem Trio

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Munters Rotem Trio and is the answer not in the manual?

Munters Rotem Trio Specifications

General IconGeneral
BrandMunters
ModelRotem Trio
CategoryFarm Equipment
LanguageEnglish

Related product manuals