Appendix A - menu system > 101
Fax Setup
a
(cont.)
Other
Settings
(cont.)
ECM Mode ON, OFF Error correction mode
(ECM) automatically
detects and corrects
errors in the fax
transmission process
that are sometimes
caused by telephone
line noise.
Prefix user defined Enter the require
dialling prefix (if you are
connected via a PBX
then you need to enter
a prefix to obtain an
outside line connection).
Received Time
Stamp
ON, OFF Set to ON if you want
the time stamp printed
on incoming faxes.
Print Check Message ON, OFF If enabled, when a
transmission error
occurs the error content
is reported.
Fax Setting Service Bit ON, OFF
Country Code International Select the country in
which the MFP is
situated.
H/Modem Rate (For
Tx)
33.6 Kbps, 28.8 Kbps,
14.4 Kbps, 9.6 Kbps,
48. Kbps
Specify modem rate.
Note: If you are using
an IP phone line and fax
Tx/Rx fails, change the
modem rate to
14.4kbps or less.
H/Modem Rate (For
Rx)
33.6 Kbps, 28.8 Kbps,
14.4 Kbps, 9.6 Kbps,
48. Kbps
PBX Line ON, OFF
Forwarding Setting ON, OFF
TAD Mode Type 1, Type 2, Type 3 Specify TAD mode type.
Tel Priority Mode ON, OFF
CNG Detection ON, OFF
T/F Timer
Programming
20 seconds,
35 seconds
Soft Ringer Volume OFF, Low, Middle, High Select volume level.
Remote Receive
Number
OFF, 000, 111, 222,
333, 444, 555, 666,
777, 888, 999
ITEM OPTION VALUE/DESCRIPTION
To Next Page
Loading...
Need help?
General
