Advanced network settings > 76
The network system reboots to enable the new settings.
Alert when an error occurs
1. Perform steps 1 to 6 in “Regular alert”.
2. Specify the time lag between when an error occurs and when the alert is sent.
If you specify a longer time, only continuing errors are notified.
3. Click OK.
4. Click View a summary of current configuration to check the current settings,
and then click X to close the window.
You can also check the current settings of up to two addresses on the main window.
Select the desired addresses from the list box.
5. Click Submit.
The network system reboots to enable the new settings.
U
SING
SNMP
V
3
The SNMPv3 manager supporting SNMPv3 encrypts the management of the machine by
SNMP.
1. Access the machine’s web page and log in as the administrator.
2. Select Admin Setup.
3. Select Network > SNMP > Setting.
4. Follow the on-screen instructions to specify the detailed settings.
5. Click Submit.
The network system reboots to enable the new settings.
NOTE
If there is no error specified, the alert e-mail in not sent.
NOTE
Your machine has an SNMP agent. You can check and change the machine
settings by a commercially available SNMP agent. For the MIB of the machine,
refer to the DVD supplied with your machine and check “Readme.text” in the
MISC > Mib folder.
To Next Page
Loading...
Need help?
General
