Appendix A - menu system > 106
Print Setup
(cont.)
Print Menu
(cont.)
Printer Adjust
Manual Timout: Disable, 30 seconds,
60 seconds
Adjust general printer
settings.
Wait Timeout: Disable, 5 seconds, 10
seconds, 20 seconds, 30
seconds, 40 seconds,
50 seconds, 60 seconds,
90 seconds, 120
seconds, 150 seconds,
180 seconds, 210
seconds, 240 seconds,
270 seconds, 300
seconds
Print Mode Without
Color Toner: Alarm, Cancel
Jam Recovery: Enable, Disable
Paper Black Setting: -2 ~ 0 ~ +2
Paper Color Setting: -2 ~ 0 ~ +2
SMR Setting: -3 ~ 0 ~ +3
BG Setting: -3 ~ 0 ~ +3
Print Position Adjust
Front X Adjust:
Front Y Adjust:
Back X Adjust:
Back Y Adjust:
0.00 mm
0.00 mm
0.00 mm
0.00 mm
Range: -2.00 to +2.00
mm
Drum Cleaning ON, OFF Set to produce idling of
a drum before printing
in order to reduce
horizontal white lines.
This shortens image
drum life.
Hex Dump ON, OFF Prints out the data
received from the host
PC in hexidecimal code.
Color Menu Density Control Auto, Manual If set to Auto, image
density will be
automatically adjusted
at power on, when a
new image drum or
toner cartridge is
installed, and at
intervals of 100, 300
and 500 drum counts. If
a 500 drum count
interval occurs during a
print job it will occur at
the end of that job, and
will take up to 55
seconds. If set to
manual, this adjustment
will only be performed
when initiated by the
next menu item.
ITEM OPTION VALUE/DESCRIPTION
To Next Page
Loading...
Need help?
General
