Section 75 00-02-0522
04-06-11 - 7 -
Press Enter and the screen should change to this display with the number quantity flashing:
Press the right arrow to reset and the display should change to:
Each timer can be acknowledged as it expires, or whenever the maintenance is done, if it
precedes the timer reaching 0.
Displaying Data
Use the Auto scroll function.
To turn the Auto scroll function ON, press the ENTER and NEXT keys at the same time. There
are three Auto scrolling speeds temporarily displayed on the top line each time ENTER and
NEXT keys are pressed (4 seconds, 8 seconds, 12 seconds). To select a different speed,
simultaneously press the ENTER and NEXT keys again to go to the next speed section. To
turn off the Auto scroll function press the EXIT and NEXT keys at the same time. If the
iGUARD is left on a non-scroll screen (like the Warnings/status screen) it will display only the
Warning/status screen.
When Programming
Touching the left arrow takes you immediately to the “TOP” of the program selection list.
The right arrow takes you immediately to the “BOTTOM” of the selection list.
Phase-out / Discontinued Product
Check Availability
To Next Page
Loading...
