EasyManua.ls Logo

Murphy iGUARD - Analog Inputs

Murphy iGUARD
64 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Section 75 00-02-0522
04-06-11 - 29 -
44. Running Cooldown
45. Air Damper N/Energized
46. Run to Destruct Enabled
47. Energized to Stop - Relay turns ON at shutdown and stays on for length of ETS timer.
48. Engine running - Engine speed is above crank disconnect speed
49. Battery Charger Fail
50. Oil Temp. High - Oil temperature is above warning setpoint.
51. Fuel Level Low Warning
52. Modem Power Enable - Used to turn modem on/off to force a known state
53. Running Warm-up and Cool-down - Reply turns on in both warm-up and cool-down
54. Not in Standby/Aux. Device
55. IDMT Warning (above pickup current)
56. IDMT Shutdown
57. Shunt Trip Alarm
Phase-out / Discontinued Product
Check Availability

Table of Contents

Related product manuals