VJ-2638/1638/1638W OPERATION MANUAL Before using
3.3 Filling ink 51
NOTE
• If the printer perform the nozzle check printing immediately after the initial ink replenishment is
complete, the following results may occur.
• Printed lines become blurred.
• The data is partially not printed.
In such cases, follow
5.3 Cleaning menu and refill a small amount of ink. Then, check the printing
result.
If there is no improvement in the print result even after refilling a small amount of ink, leave the
printer unused for an hour or more. Then, refill a small amount of ink again and check the print
result.
If there is still no improvement, contact your local MUTOH dealer.
3.3.5 When using High-capacity ink pack adapter for the first time
on the printer whose ink is filled
If the printer is used without the initial ink replenishment, the air inside High-capacity ink pack adapter
goes into Ink tubes and may cause nozzle clogging. Perform the initial ink replenishment from Cleaning
menu in the following cases.
• When using High-capacity ink pack adapter for the first time on the printer whose ink is filled
• After using High-capacity ink pack adapters and replacing them with new ones
5.3 Cleaning menu
To Next Page