Suspension and wheels
F
- 74 -
Brake caliper support flange removal
Remove the Seeger retaining ring (1), the spacer ring
(2), the flange (3) and the spacer ring underneath.
Wheel hub disassembly
Extract the wheel hub from the left side of the fork.
Carefully wash all parts.
Check the condition of the roller bearing and the ball
bearing.
If there is excessive play (even only one of the bea-
rings) or chamferings during rotation, substitute the
wheel hub, complete with bearings with a new unit.
If only one bearing is worn, substitute the
complete unit. Never substitute one bearing
only.
For normal maintenance, remove the three internal
spacers (wheel spindle seat), wash the roller bearing
units, dry them and grease them.
Check the condition of the ball bearings.
The grease used must have the following
characteristics:
– Lithium soap grease with a mineral oil base
– Consistency NLGI: 2
– Dripping point: 181° C
– Viscosity at 37.8°C: 140 cSt
– Temperature field: from -25°C to +120°C
3
1
2
To Next Page
Loading...
