Suspension and wheels
F
- 75 -
Caliper holder pin
Unscrew the caliper holder pin only if it is
damaged.
When reassembling apply the prescribed type of
Loctite and tighten to the prescribed torque pressure.
Recommended thread-locking fluid: Loctite
243
Caliper holder pin torque pressure:
30 ÷ 35 N•m
Wheel spindle unit check
Check the condition of the wheel drive engagement
splines.
If it is worn, substitute as follows.
After heating with a heat gun, remove the four fixing
screws (1) of the brake disk flange sealed with Loctite
270. Remove the flange.
Recommended thread-locking fluid: Loctite
270
30÷35 N•m
NOTE
To Next Page
Loading...
