Suspension and wheels
F
- 76 -
Check the extra-smooth parts of the wheel spindle for
wear (A).
Utilising a press with an adequate punch for both the
removal and assembly of the pins of the wheel drive
engagement.
When assembling, apply force on the crown of the peg
not on the point. (see figure).
Assemble the brake disc carrier plate by tightening the
screws to the prescribed torque pressure and then
apply Loctite 270.
Recommended thread-locking fluid: Loctite
270
Brake disc carrier plate screw torque pres-
sure: 20 ÷ 22 Nm
Crown wheel assembly check
Remove the driving flange by pushing the central ring
(1) outwards.
20÷22 N•m
1
To Next Page
Loading...
