Nabco GT 710 - User Manual

S82 W18717 Gemini Drive
Muskego, Wisconsin 53150
Phone: (877) 622-2694
Fax: (888) 679-3319
www.nabcoentrances.com
Technical Support: (866) 622-8325
Part #15-10683
Rev. 9/24/14
Low Energy Operator Swing Door Systems
Side Load Units: GT 710 and 8710
DN 1078
GT710 SIDE LOAD UNIT
Hinged Side
Access Panel
GT8710 SIDE LOAD UNIT
Hinged Side
Access Panel
WARNING
• Turn OFF all power to the Automac Door if a Safety System is not working.
• Instruct the Owner to keep all power turned OFF unl correcve acon can be achieved by a NABCO
trained technician. Failure to follow these pracces may result in serious consequences.
• NEVER leave a Door operang without all Safety detecon systems operaonal.

Summary

Chapter 3: Install the Header

Section 3 a: Inswing Doors

Section 3 b: Prepare the Header

Details steps for preparing the header unit before mounting.

Section 3 c: Prepare the Door Frame

Instructions for preparing the door frame, including measurements and reinforcement.

Section 3 d: Secure Header to the Door Frame

Guides on securing the header to the door frame using screws or lag bolts.

Chapter 4: 110 VAC General Wiring

Chapter 5: Install the First Half of Swing Arm

Section 5 a: Outswing Arm

Instructions for preparing the swing door for an outswing arm installation.

Section 5 b: Inswing Arm

Instructions for preparing the swing door for an inswing arm installation.

Chapter 6: Install the Second Half of Swing Arm

Section 6 a: Set Pre-Load

Details how to set the correct pre-load for the operator spindle.

Section 6 b: Secure the Swing Arm to the Swing Door

Chapter 7: Install the Magnets

Section 7 a: Insert the Back Check Magnet

5.2 Insert The Latch Check Magnet

Chapter 8: Adjustments

Section 8 a: LCN Tension Spring

Section 8 b: Hydraulic Speed Control (Automatic Mode)

Chapter 10: Troubleshooting

Nabco GT 710 Specifications