ENGLISH
b Use [f] button to go to Fixed Volume level setting.
c Use front panel [a/s] or SR 9’s [A/S] buttons to set preferred
dB level setting. Then, use front panel [d] or SR 9’s [D] button
to save dB level selection and exit Fixed Volume setup mode.
AUTO SENSE
Auto Sense can be setup for each Source. Auto Sense feature enables the
designated Source to wake up from standby mode when an active source
is detected from the particular Source’s input.
On: Unit wakes up to the designated Source from standby mode when
an active source is detected from the particular Source’s input.
O: Unit does not wake up to the designated Source from standby
mode even if it is triggered by an active source.
NOTES
• Auto Sense is not applicable for Phono and BluOS (if installed) sources.
• Auto Standby must be set to ON for Auto Sense to work.
ANALOG BYPASS
All analog signals remain in the analog domain without analog-to-digital
conversions.
On: DSP circuitry is bypassed but full tone control functions remain.
O: Analog bypass feature is turned o.
NOTE
Analog Bypass is applicable only for Phono, Line 1 and Line 2 sources.
ANALOG GAIN
• Use front panel [a/s] or SR 9’s [A/S] buttons to set preferred Analog
Gain level.
SYSTEM INFO
“System Info” displays information about current MCU, LCD and FPGA
rmware versions.
Use [a/s] to toggle through the corresponding information.
If the optional MDC2 BluOS D is installed, the BluOS rmware version, IP
Address, MAC Address (Ethernet) and MAC Address (Wi-Fi) information are
also shown.
OPERATION
USING C399
18
To Next Page
Loading...
Need help?
General
