Note 1： if you do not choose the data group, the scanner will take “Data group 1” as
default setting.
Note 2:
The data group is used to distinguish between different setting events.
it work on the following circumstances:
1).Differentiating the setting for different barcode types
2).Distinguish add / delete prefix or suffix
Different events can take effect at the same time.
Example 1 :
If you want to put “A” before the Code39 type barcode, put "B" before the Code128
type barcode .
The setting steps is ：
Insert charater> Code39>Data group 1 > Before barcode> 065 A> Saving settings
Insert charater> Code128>Data group 2 > Before barcode> 066 B> Saving settings
After that,
when the scanner read a Code39 barcode, it will add “ A” before the barcode. When
it read a Code128 barcode, it will add “B” before the barcode.
when it read other type barcode ,like UPC, it will not add any character.
Example 2:
To Next Page
Loading...
