If you want to put "A" before barcode, put "B" after barcode.
The setting steps is ：
Insert charater > All barcode type > Data group 1 > Before barcode > 065 A > Saving
settings
Insert charater> All barcode type > Data group 2 > After barcode > 066 B> Saving
settings
After that,
when the scanner read barcode 123456789, the barcode received by the computer will
be A123456789B.
Fourth steps ： Scan one of the following setup code to choose the position
Fifth steps ：Choose the character you want to add or the digit you want to delete.
Character table please refer to ASCIl code table on page 41.
Note 1：
Ten characters can be added or deleted at most.
Note 2：
For the character deleting event, below is the corresponding deleting characters table.
To Next Page
Loading...
