53
English
CAUITION
⑮ Connect the round terminal lugs of the Power Cord to the AC Power Input Terminal Block of
the CONTROLLER securely ¿rmly.
⑯ When using in a place where the power conditions are poor, take measures to enable a
supplied input power within the speci¿ed voltage Àuctuation.
⑰ Attach the provided Connector Cover for safety and dust proofing when not using Input /
Output Connecter A, B or EMG Connector.
⑱ Do not press the switches on the Control Panel of the CONTROLLER with a sharp-pointed tool.
⑲ When disposal of a CONTROLLER is necessary, follow the instructions from your local
government agency and dispose as an industrial waste.
⑳ Be sure to clean the collet and collet nut, the inside of the spindle before replacing the tool. If
ground particles or metal chips stick to the inside of spindle or the coll
et, damage to the collet
or spindle can occur due to the loss of precision.
㉑ Always clean the tool shank and the machine spindle taper before installing the tool in the
machine.
㉒
When sizing the correct collet size to the tool shank diameter, a tolerance of +0 ~
-
0.01mm
is
strongly recommended. A tool shank within the +0 ~
-
0.1mm range is mountable, however, this
may cause poor concentricity and or
insuf¿cient tool shank gripping force.
㉓ Select suitable products or tools for all applications. Do not exceed the capabilities of the
spindle or tools.
㉔ Carefully direct coolant spray to the tool. Do not spray directly on the motor and spindle body.
㉕ Stop working immediately when abnormal rotation or unusual vibrations are observed. If
vibrations occur, please check the contents of page number P99 "
23. TROUBLESHOOTING ".
㉖ Always check if the tool, collet or collet nut are damaged before and after operating.
㉗ After installation, repair, initial operation, or long periods of non operation, please refer to
Operation Manual of the spindle / motor spindle detailed in " BREAK-IN PROCEDURE ". When
checking the spindle, no vibration or unusual sound should be observed during rotation.
To Next Page
Loading...
Need help?
General
