Napoleon LD485RB - Lighting Instructions; Burner Lighting Guide

6
www.napoleongrills.com
Lighng Instrucons
O Posion
WARNING! Open lid
WARNING! Ensure all burner controls are in the o posion. Turn on the gas supply valve.
Main Tube Burner
Lighng
Rear Burner Lighng
(If equipped)
Side Burner Lighng
(If equipped)
1. Open grill lid. 1. Open grill lid. 1. Open/Remove side burner cover.
2. Push and turn any main burner
knob slowly to the ’hi’ posion. This
acon will ignite the pilot ame which
will in turn light the selected burner. If
the pilot lights, connue to push down
on the control knob unl the burner
lights and then release.
2. Remove the warming rack 2. Push and turn side burner control
to high posion.
3. If the pilot does not ignite, then
immediately turn the control knob
back to the ‘o posion and repeat
step 1 several mes.
.
3. Clip a match into the supplied
lighng rod. Hold a lit match to
right end ports of rear burner. Turn
rear burner to high.
3. Press and hold
igniter buon unl burner lights, or
light by match
4. If the pilot and burner will not
ignite within 5 seconds, turn the
control knob to the ‘o’ posion and
wait 5 minutes for any excess gas to
dissipate. Either repeat steps 1 and 2
or light with a match.
4. If the burner will not ignite within
5 seconds, turn the control knob to
the ‘o’ posion and wait 5 minutes
for any excess gas to dissipate. Either
repeat steps 2 and 3 or light with a
match.
WARNING! The propane cylinder is equipped with an excess ow device. Unless all burners are turned
o prior to turning the cylinder on, only small ames and low heat will be achievable.
WARNING! Do not use the rear burner (rosserie burner) with the main burners operang.
WARNING! If lighng the unit with a match, clip the match into the supplied lighng rod.
Hold the lit match down through the grill and sear plate while turning the
cor responding burner valve to high.
Le
Burner
Right
Burner
Centre
Burner
Rear
Burner