NARDA ELT-400 - Page 50

7 Remote control ELT-400
7-4
The following remote control commands can additionally be used in the
measurement phase:
Remote control command
CALC:BAT[?]<SP><param>[CR]<LF> see page 7-17
CALC:OVLD[?]<SP><param>[CR]<LF> see page 7-18
GET:MODE_INFO[?]<SP><STD><name>[CR]<LF> see page 7-8
MEAS[?][CR]<LF> see page 7-14
SEN:TYPE?[CR]<LF> see page 7-7
SET:DETECTOR[?]<SP><param>[CR]<LF> see page 7-9
SET:LOW_CUT[?]<SP><param>[CR]<LF> see page 7-10
SET:MAX_HOLD[?]<SP><param>[CR]<LF> see page 7-11
SET:MODE[?]<SP><param>[CR]<LF> see page 7-12
SET:RANGE[?]<SP><param>[CR]<LF> see page 7-13
Table 7-2 Remote control commands in the measurement phase