5 Operation
20 RadMan 2LT/2XT
5.2.3 Charging batteries
Starting the charging process:
Connect the USB-C connection of the RadMan 2 to a suitable USB port
(e.g., PC) using the supplied USB cable.
– or –
Connect the USB-C connection of the RadMan 2 to the power grid using
one of the optionally available chargers or other standard charger.
ATTENTION! The mains voltage must correspond to the permissible
operating voltage of the charger.
The charging process begins; the Battery LED flashes green during
the charging process. It takes up to 8 hours to fully charge.
Once the rechargeable batteries are fully charged, the Battery LED il-
luminates green continuously.
For further information on the various battery status displays, see Displaying
the charge state on page 22.
CAUTION
Improper charging and discharging
Improper charging or discharging may result in an explosion, a fire or
the release of chemical substances. This may lead to injuries or the
destruction of the batteries.
Only charge the rechargeable batteries as described in this operating
manual.
The charging temperature must be between 0 °C and +40 °C.
To Next Page
Loading...
