NARDA RadMan 2LT - Changing the Operating Mode (Radman 2 XT Only); Displaying the Maximum Exposure

5 Operation
24 RadMan 2LT/2XT
NOTE: After switching on, the last set integration time is applied.
5.6 Changing the operating mode
(RadMan 2XT only)
With the RadMan 2XT, it is possible to switch between the Monitor and
RF Detection operating modes. In the RF Detection operating mode, the inte-
gration time is permanently set to 30 ms to allow rapid changes to be
detected.
 The device is switched on and in the Monitor operating mode (default).
 Press 2x.
 RF Detection is active.
 The Pulse LED illuminates.
 Press 2x again to return to the Monitor operating mode.
NOTE: After switching back to the Monitor operating mode, the integration
time last set there is used again.
5.7 Displaying the maximum exposure
A maximum value display shows the highest exposure since the last time the
device was switched on.
 The device is switched on.
 Press 1x.
 The maximum exposure is indicated by the exposure LEDs.
 After 5 s, the display returns to the current exposure.
NOTE: With the RadMan 2XT, the maximum value for the two operating
modes – Monitor and RF Detection – is determined separately. The
maximum value of the selected operating mode is displayed.