National Instruments myDAQ

NI myDAQ User Guide | © National Instruments | 31
7. Click Finish to exit the Create New Express Task dialog.
8. On the Configuration tab of the DAQ Assistant front panel window, configure voltage
channel 0 by selecting Voltage_0 in the Channel Settings pane, and setting Max to 2 and
Min to -2 in the Signal Input Range pane. Repeat this step for voltage channel 1 if you
configured the task for two channels.
9. Under Timing Settings, set Acquisition Mode to Continuous Samples. Enter 5000 in
Samples to Read, and 40000 in Rate (Hz).
10. Click OK to exit the DAQ Assistant configuration front panel. The VI builds. Click No on
the Confirm Auto Loop Creation dialog box that displays.
11. Place another DAQ Assistant Express VI to the right of the previously configured DAQ
Assistant Express VI on the block diagram. The DAQ Assistant Create New Express Task
configuration window opens.
12. In the DAQ Assistant configuration window, select Generate Signals»Analog Output,
and click Voltage to select a Voltage task.
13. In the Supported Physical Channels window, select audioOutputLeft from under the
Devx (NI myDAQ) option. You can also press <Ctrl> while clicking audioOutputRight to
select both channels.
14. Click Finish to exit the Create New Express Task dialog.